4-Pin Relay/Fuse Panel With Threaded Connection, Removing And Installing: Removing

WARNING: This page is about a different variant/trim than selected.

Fig 1: Identifying 3 Pin Relay/Fuse Panel Components

Courtesy of AUDI OF AMERICA, LLC

-- Turn off the ignition and remove the key.

-- Remove the driver side instrument panel cover. Refer to DRIVER SIDE INSTRUMENT PANEL COVER, REMOVING AND INSTALLING .

-- Disengage the 3-pin relay/fuse panel by pressing the retaining springs in the direction of the -arrow- and remove the relay/fuse panel -1-.

-- Mark the electrical wires -1- and -2- before removing so they can be installed later.

Fig 2: Removing Relay/Fuse Panel

Courtesy of AUDI OF AMERICA, LLC

-- Remove the wire -1- on the 4-pin relay/relay panel.

-- Release the retaining spring -arrow A- and tilt the relay/fuse panel -3- out of the mount -arrow B-.

-- On the rear side, remove the electrical wire -2- on the 4-pin relay/fuse panel.

-- Unclip the fuse panel on relay panel.

-- Remove the relay and control modules.

Fig 3: Identifying Retaining Clips

Courtesy of AUDI OF AMERICA, LLC

-- Release the clips -arrows- and press the relay panel -2- back and out of the bracket -1-.

NOTE:

The exact assignment of the 4-pin relay/fuse panel with threaded connection can be found in the applicable Wiring Diagram(s).