LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 34 (Wiring (Coupe)) >> 97 Wiring >> Relay Panels, Fuse Panels And E-Boxes >> Relay And Fuse Panel Behind Instrument Panel On Driver Side, Removing And Installing >> 3-Pin Relay/Fuse Panel, Removing And Installing >> Removing

3-Pin Relay/Fuse Panel, Removing And Installing: Removing

WARNING: This page is about a different variant/trim than selected.
Fig 1: Identifying 3 Pin Relay/Fuse Panel Components
GWWA97-10477Courtesy of AUDI OF AMERICA, LLC

-- Turn Off The Ignition And Remove The Key.

-- Remove The Driver Side Instrument Panel Cover. Refer To DRIVER SIDE INSTRUMENT PANEL COVER, REMOVING AND INSTALLING .

-- Disengage The 3-Pin Relay/Fuse Panel By Pressing The Retaining Springs In The Direction Of The -Arrow- And Remove The Relay/Fuse Panel -1-.

-- Unclip The Fuse Panel On The Relay/Relay Panel.

-- Remove The Relay And Control Modules.

Fig 2: Identifying Retaining Clips
GWWA97-10472Courtesy of AUDI OF AMERICA, LLC

-- Release The Clips -Arrows- And Press The Relay Panel -2- Back And Out Of The Bracket -1-.

NOTE:

The exact assignment of the 3-pin relay/fuse panel can be found in the applicable wiring diagram. Refer to theAppropriate Wiring Diagram(s) .

scientia non olet · About LEMON Manuals