Left Instrument Panel Fuse Panel, Removing And Installing: Removing

WARNING: This page is about a different variant/trim than selected.

-- With The Ignition Switched Off, Disconnect The Battery Ground Cable. Refer To BATTERY, DISCONNECTING AND CONNECTING .

NOTE:

Remove The Driver Side Upper Instrument Panel Cover, If Necessary. Refer To DRIVER SIDE INSTRUMENT PANEL COVER, REMOVING AND INSTALLING .

-- Remove the fuses from the fuse panel.

Fig 1: Releasing Clips And Removing Cover From Fuse Holder

Courtesy of AUDI OF AMERICA, LLC

-- Release clips -arrows- and remove the cover from the fuse panel.

-- Remove the retaining strip -1- for the connectors -arrow- and remove the connectors from the plug-in socket.

Fig 2: Pulling Off Retaining Strip

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Check the exact assignment for left instrument panel fuse panel in the applicable wiring diagram. Refer to the Appropriate Wiring Diagram(s) .