Vehicle Electrical System Control Module -J519-, Removing And Installing: Removing

WARNING: This page is about a different variant/trim than selected.

Fig 1: Identifying 3 Pin Relay/Fuse Panel Components

Courtesy of AUDI OF AMERICA, LLC

-- Turn Off The Ignition And Remove The Key.

-- Remove The Driver Side Instrument Panel Cover. Refer To DRIVER SIDE INSTRUMENT PANEL COVER, REMOVING AND INSTALLING .

-- Disengage The 3-Pin Relay/Fuse Panel By Pressing The Retaining Springs In The Direction Of The -Arrow- And Remove The Relay/Fuse Panel -1-.

-- Remove The Wire -1- On The 4-Pin Relay/Relay Panel.

Fig 2: Removing Relay/Fuse Panel

Courtesy of AUDI OF AMERICA, LLC

-- Release The Retaining Spring -Arrow A- And Tilt The Relay/Fuse Panel -3- Out Of The Mount -arrow B-.

NOTE:

Ignore -Item 2-.

-- Release The Spring -Arrow- And Remove The Vehicle Electrical System Control Module -J519- -Item 1- Downward From The Mount.

Fig 3: Removing Electrical System Control Module

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect The Connectors -2, 5, 6, 7 And 8-.

-- Disconnect The Connectors -3- And -4-.

-- To Disconnect The Connector, Press The Catch -1-, Rotate The Retaining Bracket In The Direction Of The -Arrow- And Remove The Connector.

Fig 4: Catch And Retainer

Courtesy of AUDI OF AMERICA, LLC