Special Purpose Vehicle Control Module -J608-, Removing And Installing, Coupe: Removing

Fig 1: Identifying Comfort System Central Control Module Retaining Frame

Courtesy of AUDI OF AMERICA, LLC

-- With The Ignition Switched Off, Disconnect The Battery Ground Cable. Refer To BATTERY, DISCONNECTING AND CONNECTING .

-- Open The Cover For The Right Luggage Compartment Side Trim Panel.

-- Remove The Nuts -Arrows- And Move The Frame -1- With The Comfort System Central Control Module -J393- To The Side.

-- Release The Clips -Arrows-, If Equipped, And Remove The Electronic Damping Control Module -J250- -Item 1- From The Retaining Frame.

Fig 2: Removing Electronic Damping Control Module

Courtesy of AUDI OF AMERICA, LLC

-- Remove The Screws -1- And -2- And The Nut -4-.

Fig 3: Identifying Frame, Bolts & Nut

Courtesy of AUDI OF AMERICA, LLC

-- Tilt The Retaining Frame -3- With Control Modules To The Side.

-- Disconnect The Connectors From The Control Modules In The Retaining Frame.

-- Remove The Retaining Frame With Control Modules.

-- Press The Clip -1- In Direction Of The -arrow A- And Tilt The Special Purpose Vehicle Control Module -J608- -Item 2- In Direction Of The -arrow B- Out Of The Frame -3-.

Fig 4: Removing Special Purpose Vehicle Control Module

Courtesy of AUDI OF AMERICA, LLC