Data Bus On Board Diagnostic Interface -J533-, Removing And Installing: Removing

WARNING: This page is about a different variant/trim than selected.

Fig 1: Data Bus On Board Diagnostic Interface -J533-

Courtesy of AUDI OF AMERICA, LLC

-- Turn off the ignition and remove the key.

-- Remove The Glove Compartment. Refer To GLOVE COMPARTMENT, REMOVING AND INSTALLING .

-- Remove The Bolt -2-.

-- Pivot The Data Bus On Board Diagnostic Interface -J533- -Item 3- Out Of The Bracket -Arrow-.

-- Disconnect The Connector -4-.

-- Disconnect The Fiber Optic Cable Connector -1-.

-- Seal The Open Wiring Harness Connector -2- For The Fiber-Optic Cable With The Fiber-Optic Repair Set - Connector Protective Caps:VAS6223/9 -Item 1-.

Fig 2: Fiber-Optic Cable Harness Connector And Protective Cap For Cable Connector VAS 6223/9

Courtesy of AUDI OF AMERICA, LLC

NOTE:

The Protective Cap Prevents Contamination Of Or Mechanical Damage To The Front Surface Of The Fiber-Optic Cable Which Would Impair Signal Transmission.