Refrigerant Circuit Connections With Valve For Switches
WARNING: This page is about a different variant/trim than selected.
NOTE:
Switch pressures, removing and installing switches as well as switch arrangement and version. Refer to vehicle specific refrigerant circuit. Refer to REFRIGERANT CIRCUIT - 1 , REFRIGERANT CIRCUIT - 2 , REFRIGERANT CIRCUIT 1234yf - 1 , REFRIGERANT CIRCUIT 1234yf - 2 , REFRIGERANT CIRCUIT GENERAL INFORMATION R134a , REFRIGERANT CIRCUIT R134a (Vehicle-Specific Repair Information).
- Different Threads For Switch On High Pressure And Low Pressure Sides.
- Only Valves And O-Ring Seals That Are Resistant To Refrigerant R134a And Refrigerant Oil Must Be Installed.
A - Connection (Soldered In)
B - O-Ring Seal
C - Valve (With O-Ring Seal)
NOTE:
To remove and install the valve insert -C- when the refrigerant circuit is discharged, use, for example, an adapter from the Refrigerant Sockets:T10364 (for the tightening specification. Refer to CONNECTIONS WITH SCHRADER VALVE (NEEDLE VALVE) ).