Fresh Air Blower Control Module -J126-, Removing And Installing: Removing

WARNING: This page is about a different variant/trim than selected.

-- Move The Passenger Seats As Far Back As Possible.

-- Turn Off The Ignition.

-- Remove the glove compartment. Refer to GLOVE COMPARTMENT, REMOVING AND INSTALLING .

-- Disconnect the connector -A and B-.

Fig 1: Disconnecting Connectors

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -C-.

WARNING:

The heat sink on Fresh Air Blower Control Module -J126- may be hot.

-- Remove the Fresh Air Blower Control Module -J126- -D- from the air intake housing.