Traction Battery -A2- Inlet Air Guide, Removing And Installing: Installing
WARNING: This page is about a different variant/trim than selected.
Installation Is Carried Out In The Reverse Order While Observing The Following.
NOTE:
Use a bolt -5- to attach the air guide to the battery cooling module -6- and use bolts -2 and 3- to attach the left -1- and right -4- air guides if the retainers no longer hold or if one of the tabs breaks off.
-- Clip the inlet air guide inside the battery cooling module -6- in direction of -arrow B- first, then install the left -1- and right -4- air guides in direction of -arrows A-.
-- Install The Removed Parts In The Opposite Order