Traction Battery -A2- Front Outlet Air Guide, Removing And Installing: Installing

WARNING: This page is about a different variant/trim than selected.

Fig 1: Installing Front Outlet Air Guide

Courtesy of AUDI OF AMERICA, LLC

Installation is carried out in the reverse order while observing the following.

NOTE:

Use bolts -2, 3 and 4- to attach the air guide to the battery cooling module -7- if the retainers -6- do not hold any longer or one of the tabs -1 and 5-.

-- Clip the front outlet air guide inside the battery cooling module -7- -arrow B- first, then install the left -1- and right -5- air guides in direction of -arrows A-.

-- Electrical connections and routing. Refer to Wiring Diagram.

-- Reinstall all of the previously removed components.

-- Turn on the ignition.

-- Check the DTC memory for the Climatronic Control Module -J255- A/C display and control head and erase any displayed malfunctions, if necessary using the Vehicle Diagnostic Tester in the "Guided Fault Finding" function.