Sunlight Photo Sensor -G107-, Removing And Installing: Removing
WARNING: This page is about a different variant/trim than selected.
-- Turn off the ignition.
-- Carefully pry the Sunlight Photo Sensor -G107- -A- out of the defroster vent -B- (for the windshield) using a small screwdriver. Refer to SUNLIGHT PHOTO SENSOR -G107-, REMOVING AND INSTALLING .
NOTE:
While Doing So, Do Not Damage The Surface Of The Cover For The Sunlight Photo Sensor -G107- -A- And The Defroster Vent -B-.
-- Disconnect The Connector -C-.