Brakes Inspection

WARNING: This page is about a different variant/trim than selected.

The testing takes place on a test stand.

When testing, place selector lever in driving position N for vehicles with automatic transmission and in neutral position for vehicles equipped with manual transmission.

Always observe the test stand manufacturer instructions.

NOTE:

Electronic brake control systems are inoperative when the ignition is switched off.

If Testing Equipment is Needed on Road Tests, Follow the Information Below

Fig 1: Identifying Diagnostic Tester Operator Wearing Safety Belt

Courtesy of AUDI OF AMERICA, LLC

WARNING:

Distraction and testing equipment that is not secured properly increase the risk of an accident.

The passenger airbag could be dangerous if it deploys during an accident.

Operating testing equipment while driving is a distraction.
Testing equipment that is not secured probably increases the risk of injury.

Move the passenger seat as far back as possible.
Only use the vehicle diagnostic tester VAS 5051B or VAS 5052.
Testing equipment -1- must lie flat on the passenger's lap as shown in the illustration and must only be operated by that passenger.