Left Center Vent Motor -V110-, Removing And Installing: Installing

WARNING: This page is about a different variant/trim than selected.

Installation Is Carried Out In The Reverse Order While Observing The Following.

-- Check The Lever Pin -G- And The Connector Rod Pin -F- For Proper Seating In The Respective Guiding Groove In The Curved Washer -E-.

Fig 1: Check Lever Pin And Connector Rod Pin For Correct Fit

Courtesy of AUDI OF AMERICA, LLC

-- Insert The Shaft -D- Of The Actuator -B- Into The Curved Washer -E-.

NOTE:

The Actuator Does Not Have A Stop; Therefore The Actuator Shaft Can Be Inserted Into The Curved Washer -E- In Any Position.

-- Install The Bolts -C-.

-- Connect The Connector -D-.

-- Install The Wiring Harness So That It Cannot Come In Contact With Any Moving Parts (For Example, The Actuating Arm).

-- Install The Removed Parts In The Opposite Order.

-- Turn On The Ignition.

-- Perform A Basic Setting And The Output Diagnostic Test Mode For The A/C System Using The Vehicle Diagnostic Tester In The "Guided Fault Finding " Function.

NOTE:

On This Vehicle, The Actuators Are Equipped With Electronics. During The Basic Setting, A New Actuator Learns Its Position On The A/C Unit And Can Then Be Activated By The Climatronic Control Module -J255- A/C Display And Control Head (Currently All Actuators Are Identical) Using The Vehicle Diagnostic Tester In The "Guided Fault Finding " Function.

During The Basic Setting, The Actuators Are Assigned And Adapted Corresponding To The Switching Sequence Of The Wiring. If This Sequence Does Not Conform The Specification, The Adjustment Motors Will Adapt Incorrectly And The Door Control Will Be Wrong. Refer To MAIN WIRING DIAGRAM FOR A/C SYSTEM ACTUATORS .

-- Check The DTC memory for the Climatronic Control Module -- A/C display and control head and erase any displayed malfunctions, if necessary using the Vehicle Diagnostic Tester in the "Guided Fault Finding " function.