Hybrid BATTERY RECIRCULATION DOOR POSITIONING MOTOR 1 -V479-, REMOVING AND INSTALLING: Installing
WARNING: This page is about a different variant/trim than selected.
Installation Is Carried Out In The Reverse Order While Observing The Following.
-- Install The Remaining Removed Components.
-- Turn On The Ignition.
-- After Installing, Check The DTC Memory For The Climatronic Control Module -J255- Display And Control Head And The Battery Regulation Control Module -J840- And, If Necessary, Erase The Displayed Faults Using The Vehicle Diagnostic Tester In The "Guided Fault Finding " Function.
-- Perform A Function Test And, If Necessary, An Output Diagnostic Test For Both Of The Actuators On The Battery Cooling Module Via The Battery Regulation Control Module -J840- Using The Vehicle Diagnostic Tester In The "Guided Fault Finding " Function.