Center Vent Adjustment Motor -V102-, Removing And Installing: Removing
WARNING: This page is about a different variant/trim than selected.
-- Move the passenger seats as far back as possible.
-- Turn off the ignition.
-- Remove the glove compartment. Refer to STORAGE COMPARTMENTS AND COVERS .
-- Remove the right footwell vent (front passenger side). Refer to FRONT PASSENGER SIDE FOOTWELL VENT, REMOVING AND INSTALLING .
-- Remove bolts -A-.
-- Remove the air guide channel -B- leading to the right instrument panel vent (passenger side).
-- Mark the connector -A- if necessary (to rule out an interchange in the event several connectors are disconnected at the same time).
-- Disconnect the connector -A-.
-- Remove the bolts -B-.
-- Remove the shaft -D- of the actuator -C- from the center vent door shaft -E-.