Center Vent Adjustment Motor -V102-, Removing And Installing: Notes
WARNING: This page is about a different variant/trim than selected.
NOTE:
The Center Vent Adjustment Motor -V102- Is Only Installed On Vehicles Equipped With The "Basis" A/C System.
Currently in this vehicle, all actuators are identical in construction. During the basic setting, the actuators are assigned and adapted corresponding to the switching sequence of the wiring. If this sequence does not conform the specification, the adjustment motors will adapt incorrectly and the door control will be wrong. Refer to MAIN WIRING DIAGRAM FOR A/C SYSTEM ACTUATORS .