LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 29 (Air Conditioning (A/C Compressor) (Coupe)) >> 87 Air Conditioning >> A/C Compressor >> Belt Pulley, Removing And Installing >> BELT PULLEY, REMOVING AND INSTALLING, A/C COMPRESSOR WITH A/C Clutch -N25- >> Belt Pulley, Removing

Belt Pulley, Removing

WARNING: This page is about a different variant/trim than selected.
NOTE:

Remove The Belt Pulley -A- As Described Below If It (After Removing The Locking Ring) Will Not Come Off The A/C Compressor Flange By Hand (For Example, Due To Dirt Build-Up).

Fig 1: Removing Belt Pulley
GWWA87-11104Courtesy of AUDI OF AMERICA, LLC

Mount The Arms On The Puller So That The Outside Of The Belt Pulley Does Not Get Bent If The Belt Pulley -A- Is Going To Be Used Again.

-- Remove The Belt Pulley -A- With A 3-Arm Puller -B-.

NOTE:

Do Not Support The Puller Spindle -B- On The A/C Compressor Shaft When Removing The Belt Pulley -A-.

Use A Sleeve -C- (For Example, Sleeve Vag 1719/1 Taken From A/C Clutch Set:VAG1719  ) To Support The Spindle On The Arm Puller -B- On The A/C Compressor Flange.

Clean The Flange On The A/C Compressor Thoroughly After Removing The Belt Pulley -A-. It Must Possible To Install The Belt Pulley -A- By Hand.

scientia non olet · About LEMON Manuals