LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 29 (Air Conditioning (A/C Compressor) (Coupe)) >> 87 Air Conditioning >> A/C Compressor >> A/C Compressor Input Shaft, Removing And Installing >> Installing The Input Shaft

Installing The Input Shaft

WARNING: This page is about a different variant/trim than selected.

Install In Reverse Order Of Removal. Note The Following: 

-- Check The Input Shaft -B-, Splines Must Show No Traces Of Wear And Must Be Seated Free Of Play In Splines Of Drive Wheel -C-.

-- Prior To Installation, Coat The Input Shaft Splines -B-, For Example, With Lubricating Grease:G 000 100  .

-- Insert The Input Shaft -B- Before Installing A/C Compressor And Slide It Into Drive Wheel -C- Up To Stop.

Fig 1: Identifying Boot, Drive Shaft & Drive Pinion Splines
GWWA87-0621Courtesy of AUDI OF AMERICA, LLC

-- After Installing A/C Compressor, Check The Position Of The Grommet -A-.

NOTE:

A Clamp On The Power Take-Off Flange Keeps The Grommet -A- From Sliding Off. .

scientia non olet · About LEMON Manuals