Sun Shade, Removing And Installing: Installing
WARNING: This page is about a different variant/trim than selected.
Install In Reverse Order Of Removal. Note The Following:
-- If Removed, Install The Rear Of The Rear Shelf -2- On The Sun Shade -1- -Arrows-, Aligning Both Parts To Each Other.
-- Insert The Sun Shade -1- With The Rear Shelf Into The Rear Shelf Mount -2- -Arrows-.
-- Tighten The Sun Shade Bolts -Arrows-.
-- Carefully Insert The Guide Strip -1- Into The Sun Shade Connecting Piece -2- In Direction Of -Arrow-.
- The Sun Shade Guide Channel Must Run Into The Guide Strip Without The Connecting Piece Being Offset.
-- Clip Guide Piece -3- At Both Retaining Hooks -2- And -4- On The Front And Rear With Connecting Piece -1-.
Fig 5: Clip Guide Strip -3- At Both Retaining Hooks -2- And -4- On Front And Rear With Connecting Piece -1
-- To Ensure The Retaining Hooks -1- Are Seated Securely, Pull Them Forward Until They Engage Completely Using An Offset Screwdriver In Direction Of -Arrow-.