Inner Tail Lamps, Removing And Installing: Installing
WARNING: This page is about a different variant/trim than selected.
Install In Reverse Order Of Removal. Note The Following:
- Tightening Specification. Refer to OVERVIEW - REAR LID TAIL LAMPS .
NOTE:
Make Sure The Seal Between The Body And Tail Lamp Housing Seals Correctly.
-- Position the inner tail lamp on the outer edge of the rear lid.
-- Slide the small clamping bracket -4- onto the threaded pins on the inner tail lamp and install the nut -5- loosely.
Fig 1: Sliding Large Clamping Bracket -3- Onto Inner Tail Lamp Threaded Pins. Guide Pins -2- & -6- Must Engage In Mounts
-- Slide the large clamping bracket -3- onto the inner tail lamp threaded pins. The centering pins -2- and -6- must engage in the mounts.
-- Tighten the nuts -1- and -5- by hand.
NOTE:
When Tightening The Nuts, The Clamping Bracket Wedges Itself Onto The Rear Lid -Arrows-.