Inner Tail Lamp, Removing And Installing, Led From My 2013: Installing

WARNING: This page is about a different variant/trim than selected.

Fig 1: Identifying Clamping Brackets & Nuts

Courtesy of AUDI OF AMERICA, LLC

Install In Reverse Order Of Removal. Note The Following:

NOTE:

Make Sure The Seal Between The Body And Tail Lamp Housing Seals Correctly.

-- Slide the clamping brackets -1, 4 and 5- onto the inner tail lamp threaded pins and turn the nuts -2, 3 and 6- 3 turns.

-- Position the inner tail lamp on the outer edge of the rear lid so that the clamping bracket audibly engages.

-- Tighten the nuts. Refer to Figure.

NOTE:

When Tightening The Nuts, The Clamping Bracket Wedges Itself Onto The Rear Lid -Arrows-.