Left/Right Back-Up Lamp Bulb 2 - M76- / - M77-, Removing And Installing: Installing
WARNING: This page is about a different variant/trim than selected.
- Tightening Specification. Refer to OVERVIEW - REAR LID TAIL LAMPS .
Install In Reverse Order Of Removal. Note The Following:
-- Insert the new bulb in the socket without touching the bulb glass with bare hands.
-- Slide the large clamping bracket -3- onto the inner tail lamp threaded pins. The centering pins -2- and -6- must engage in the mounts.
Fig 1: Sliding Large Clamping Bracket -3- Onto Inner Tail Lamp Threaded Pins. Guide Pins -2- & -6- Must Engage In Mounts
-- Tighten the nuts -1-.
NOTE:
When Tightening The Nuts, The Clamping Bracket Wedges Itself Onto The Rear Lid -arrows-.
Ignore -items 4 and 5-.