Access/Start Authorization Switch -E415-, Removing And Installing: Installing

• Tightening Specification. Refer to Figure.

Install In Reverse Order Of Removal. Note The Following: 

-- Install The Gap Cover For The Instrument Cluster. Refer To INSTRUMENT CLUSTER GAP COVER, REMOVING AND INSTALLING .

-- Install The MMI Screen Cover. Refer To MMI SCREEN COVER, REMOVING AND INSTALLING .

-- For USA Vehicles: Install The Right Impact Absorber. Refer To BUMPER / IMPACT ABSORBER, REMOVING AND INSTALLING / INSTRUMENT PANEL CENTRAL TUBE, REMOVING AND INSTALLING .

-- Install The Driver Side Instrument Panel Cover. Refer to DRIVER SIDE INSTRUMENT PANEL COVER, REMOVING AND INSTALLING .

Connector Assignment For Access/Start Authorization Switch -E415- 

3  - Not Assigned

4  - Not Assigned

5  - S-contact

6  - Terminal 15

7  - LIN

8  - Terminal 30

9  - Not Assigned

10  - Not Assigned

11  - Not Assigned

12  - Not Assigned

13  - RED2, terminal 15

14  - RED, terminal 15

15  - Ignition/starter switch +

16  - Terminal 31