Parking Aid Control Module -J446-, Removing And Installing, With Trailer Hitch: Removing
WARNING: This page is about a different variant/trim than selected.
-- Open the cover for the right luggage compartment side trim panel.
-- Remove the nuts -1- and -3-.
-- Disengage the electrical wire from the guides -arrows- on the retaining frame -2- and disconnect the cable tie -4-.
-- Remove the retaining frame upward.
-- Disconnect the connectors -2 through 4-.
-- Release the clip -arrow- and remove the Parking Aid Control Module -J446- -item 5- from the frame -1-.