LEFT/RIGHT POSITION LAMP BULB -M1- / -M3-, REMOVING AND INSTALLING, HALOGEN HEADLAMPS, From MY 2013: Installing

WARNING: This page is about a different variant/trim than selected.

Install In Reverse Order Of Removal. Note The Following:

-- Insert the new bulb past the resistance of the spring clips into the housing and connect to the connector. This way the bulb glass is not touched with bare hands.

-- Close the housing cover -1-. At the same time, the tab -3- must align with the marking -2- on the headlamp housing.

Fig 1: Close Housing Cover

Courtesy of AUDI OF AMERICA, LLC

-- On the right: install the air filter housing. Refer to AIR FILTER HOUSING, LOWER SECTION [CALA] , AIR FILTER HOUSING, LOWER SECTION [CAKA, CCBA, CMUA, CGWC, CGXC, CHMB, CTUB] , AIR FILTER HOUSING [CFSA] , AIR FILTER HOUSING [CAEB, CPMA] , AIR FILTER HOUSING, REMOVING AND INSTALLING [CAUA] .