Headlamp, Removing And Installing, Halogen Headlamps, From 11/2008: Installing
WARNING: This page is about a different variant/trim than selected.
- Tightening Specification. Refer to OVERVIEW - HALOGEN HEADLAMPS, FROM 11/2008 .
Install In Reverse Order Of Removal. Note The Following:
-- When inserting the headlamp -2- into the mount -1-, make sure the guide tracks on the headlamp engage in the guides on the mount -arrows-.
- Headlamp must slide gently into mount and without using force.
-- When sliding the headlamp -4- in, make sure the headlamp ventilation -3- slides evenly into the mount -2- for the ventilation hose -1- -arrow-.
Fig 2: Identifying Headlamp -4-, Headlamp Ventilation -3-, Mount -2- And Ventilation Hose -1- -Arrow-
-- Tighten the bolts -2, 3 and 5-.
-- Install The Lock Carrier Cover. Refer To LOCK CARRIER COVER, REMOVING AND INSTALLING / OVERVIEW - LOCK CARRIER .