Headlamp, Changing From LHD To RHD, Halogen Headlamps From 11/2008: Procedure

WARNING: This page is about a different variant/trim than selected.

NOTE:

The Cover Foil Has A Molding (Marking Foil), Which Must Be Placed Along The Line Around The Headlamp Lens So That It Covers The Asymmetrical Area Of The Low Beam.

-- Clean The Headlamp Glasses And Dry Them.

DRIVER SIDE HEADLAMP:

Fig 1: Cover Foil

Courtesy of AUDI OF AMERICA, LLC

-- Peel off the protective film from the protective backing.

-- Lay the cover foil flush along the line -2- going around the headlamp lens.

-- Affix the cover foil to the headlamp lens as illustrated.

-- Separate the marking foil -1- from the cover foil -3- at the perforation -arrow- and pull it off the headlamp lens.

FRONT PASSENGER SIDE HEADLAMP:

Fig 2: Cover Foil

Courtesy of AUDI OF AMERICA, LLC

-- Peel off the protective film from the protective backing.

-- Lay the cover foil flush along the line -2- going around the headlamp lens.

-- Affix the cover foil to the headlamp lens as illustrated.

-- Separate the marking foil -3- from the protective backing -1- at the perforation -arrow- and pull it off the headlamp glass.