HEADLAMP, CHANGING FROM LHD TO RHD, HALOGEN HEADLAMPS From MY 2012, USA From MY 2013: Procedure

WARNING: This page is about a different variant/trim than selected.

NOTE:

The Cover Foil Has A Molding (Marking Foil), Which Must Be Placed Along The Line Around The Headlamp Lens So That It Covers The Asymmetrical Area Of The Low Beam.

-- Clean The Headlamp Glasses And Dry Them.

DRIVER SIDE HEADLAMP:

Fig 1: Cover Foil

Courtesy of AUDI OF AMERICA, LLC

-- Peel off the protective film from the protective backing.

-- Place the protective backing starting on the corner -1- flush along the line -2- going around the headlamp glass.

-- Affix the cover foil to the headlamp lens as illustrated.

-- Separate the marking foil -4- from the cover foil -3- at the perforation -arrow- and pull it off the headlamp lens.

FRONT PASSENGER SIDE HEADLAMP:

Fig 2: Cover Foil

Courtesy of AUDI OF AMERICA, LLC

-- Peel off the protective film from the protective backing.

-- Place the protective backing starting on the corner -4- flush along the line -3- going around the headlamp glass.

-- Affix the cover foil to the headlamp lens as illustrated.

-- Separate the marking foil -1- from the protective backing -2- at the perforation -arrow- and pull it off the headlamp glass.