Headlamp Adjustment

WARNING: This page is about a different variant/trim than selected.

Fig 1: Identifying Headlight Setting Line, Break-Away Point & Center Point

Courtesy of AUDI OF AMERICA, LLC

The horizontal light-dark border must touch the dividing line -1- on the adjusting unit test surface.
The bend point -2- between the left horizontal part and the right rising part of the light-dark border must run vertically through the central mark -3-. The bright core of the light beam must be to the right of the vertical.

NOTE:

To Determine The Bend Point -2- More Easily, Cover And Uncover The Left Half Of The Headlamp (seen In Direction Of Travel) Several Times. Then Check The Low Beam Again.

After adjusting the low beam according to the instructions, the center of the high beam light beam must be on the central marking -3-.

-- To adjust the height of the headlamp, set the light-dark border just under the dividing line with the adjustment screw -1-.

Fig 2: Identifying Adjustment Screw -1- & Adjusting Screw -2-

Courtesy of AUDI OF AMERICA, LLC

-- Then adjust the light-dark border on the dividing line starting from the bottom.

-- For side adjustment, turn the adjusting screw -2-.

NOTE:

The Right Headlamp Layout Is A Mirror Image.