Overview - Automatic Headlamp Range Control

WARNING: This page is about a different variant/trim than selected.

Fig 1: Automatic Headlamp Vertical Aim Control Overview

Courtesy of AUDI OF AMERICA, LLC

Right Headlamp Beam Adjustment Motor -V49-
- Various periods of time are determined depending on the model version.
- Removing and installing. Refer to LEFT/RIGHT HEADLAMP BEAM ADJUSTMENT MOTOR -V48- / -V49-, REMOVING AND INSTALLING .
Control Module
- Vehicles without cornering lamps: Headlamp Range Control Module -J431-
- Vehicles with cornering lamps: Cornering Lamp and Headlamp Range Control Module -J745-
- Removing and installing. Refer to HEADLAMP RANGE CONTROL MODULE, REMOVING AND INSTALLING .
- Depending on the version From MY 2012, USA From MY 2013, it is integrated in the Vehicle Electrical System Control Module -J519-.
Connector
Left Rear Level Control System Sensor -G76-
- Component Location: On The Left Rear Control Arm
- Removing and installing. Refer to LEFT/RIGHT REAR LEVEL CONTROL SYSTEM SENSOR -G76- / -G77-, REMOVING AND INSTALLING .
Left Front Level Control System Sensor -G78-
- Component Location: On The Left Front Control Arm
- Depending On The Date Of Manufacture
- Removing and installing. Refer to LEFT/RIGHT REAR LEVEL CONTROL SYSTEM SENSOR -G76- / -G77-, REMOVING AND INSTALLING .
Left Headlamp Beam Adjustment Motor -V48-
- Various Periods Of Time Are Determined Depending On The Model Version.
- Removing and installing. Refer to LEFT/RIGHT HEADLAMP BEAM ADJUSTMENT MOTOR -V48- / -V49-, REMOVING AND INSTALLING .