Lane Change Assistance Control Module -J769- /Lane Change Assistance Control Module 2 -J770-, Calibrating: Procedure
-- Switch on the Calibration Tool - Lane Change Calibration Tool -VAS6350/4- at the voltage switch -3-.
- The green LED -1- must turn on.
If the red LED -2- comes on: Check the Calibration Tool - Lane Change Calibration Tool -VAS6350/4-.
-- Continue to follow the instructions in the Vehicle Diagnostic Tester display.
During the program sequence, a request is made to switch the Calibration Tool - Lane Change Calibration Tool -VAS6350/4- from the right to the left side of the Calibration Unit:VAS6350A .
-- Switch the Calibration Tool - Lane Change Calibration Tool -VAS6350/4- off and move device.
- When installed correctly, the vehicle electrical system voltage wire must be connected at the bottom left of calibration device (as seen in direction of travel).
Dimension -a- is measured from the upper edge of the calibration device to the floor.
| Model | A5/S5 Coupe | A5/S5 Sportback | RS 5 Coupe | |
|---|---|---|---|---|
| Adjustment dimension height in mm dimension -a- | SWA 1.0 | 700 | - | - |
| SWA 1.5 | 700 | 800 | 700 | |
| SWA 2.0 | 759 | 856 | 722 |
-- The indicator on the base of the Calibration Tool - Lane Change Calibration Tool -VAS6350/4- must align with adjustment dimension on the measuring scale -1- on measuring field -arrow-.
| Model | A5/S5 Coupe | A5/S5 Sportback | RS 5 Coupe | |
|---|---|---|---|---|
| Left adjustment dimension read in mm on the measuring scale -1- | SWA 1.0 | 586 | - | - |
| SWA 1.5 | 745 | 690 | 590 | |
| SWA 2.0 | 613 | 670 | 585 |
-- Switch on the Calibration Tool - Lane Change Calibration Tool -VAS6350/4- at the voltage switch -3-.
- The green LED -1- must turn on.
-- Continue to follow the instructions in the Vehicle Diagnostic Tester display.
-- After calibrating the lane change assistance successfully, end "calibration", switch off the ignition and disconnect the diagnostic connector.