Lane Change Assistance Control Module -J769- /Lane Change Assistance Control Module 2 -J770-, Removing And Installing, SPORTBACK: Removing

WARNING: This page is about a different variant/trim than selected.

Fig 1: Identifying Lane Change Assistance Control Module

Courtesy of AUDI OF AMERICA, LLC

-- If replacing the control module, select the "Replace control module" function for the corresponding control module on the Vehicle Diagnostic Tester.

-- Remove the rear bumper cover. Refer to REAR BUMPER .

-- Disconnect the connector -3-.

-- Remove the bolts -1- and -2-.

-- Remove the lane change assistance control module from the mount on the bumper -arrow-.