Tunnel-Side Trim, Removing And Installing, Standard Seat, Sport Seat, Super Sport Seat: Removing
WARNING: This page is about a different variant/trim than selected.
WARNING:
- Follow All Safety Precautions When Working With Pyrotechnic Components. Refer To SAFETY PRECAUTIONS .
- Before Handling Pyrotechnic Components (For Example, Disconnecting The Connector), The Person Handling It Must "Discharge Static Electricity". This Can Be Done By Touching The Door Striker, For Example.
-- Turn On The Ignition.
-- Move The Front Seat To The Highest Position.
-- Disconnect The Battery Ground Cable With The Ignition Turned On. Refer To BATTERY, DISCONNECTING AND CONNECTING .
-- Remove The Front Seat:
- Standard seat and Sport seat (manual). Refer to FRONT SEAT, REMOVING AND INSTALLING, MANUAL .
- Standard seat, Sport seat (power) and Comfort seat. Refer to FRONT SEAT, REMOVING AND INSTALLING, POWER .
- For the super sport seat. Refer to FRONT SEAT, REMOVING AND INSTALLING, POWER .
-- Attach the front seat to the Engine/Transmission Holder - Seat Repair Fixture:VAS6136 . Refer to FRONT SEAT, MOUNTING ON FIXTURE FOR SEAT REPAIR .
-- Remove the expanding rivets -3 and 4-.
-- Remove tunnel side trim panel -2- upward.
NOTE:
Make Sure The Tab -1- Is Not Damaged When Removing The Trim.