Tunnel-Side Trim, Removing And Installing, Bucket Seat: Removing
WARNING: This page is about a different variant/trim than selected.
-- Remove the bucket seat. Refer to FRONT SEAT, REMOVING AND INSTALLING, BUCKET SEAT .
-- Secure the front bucket seat to the Engine/Transmission Holder - Seat Repair Fixture:VAS6136 . Refer to FRONT SEAT, MOUNTING ON FIXTURE FOR SEAT REPAIR .
-- Remove the right backrest cover. Refer to BACKREST COVER, REMOVING AND INSTALLING, BUCKET SEAT .
-- Remove the seat belt latch. Refer to FRONT SEAT BELT LATCH, REMOVING AND INSTALLING .
NOTE:
Do Not Disconnect The Electrical Harness Connectors.
-- Press the locking pin inward and remove the expanding clip -1-.
-- Release clip -3- in direction of -arrow A- and remove trim -2- on the tunnel side upward and toward the front in direction of -arrow B-.