Seat Height Adjustment, Removing And Installing, Manual Standard Seat/Sport Seat: Removing
WARNING: This page is about a different variant/trim than selected.
WARNING:
- Follow all Safety Precautions when working with pyrotechnic components. Refer to SAFETY PRECAUTIONS .
- Before handling pyrotechnic components (for example, disconnecting the connector), the person handling it must "discharge static electricity". This can be done by touching the door striker, for example.
-- Turn on the ignition.
-- Disconnect the battery ground cable with the ignition turned on. Refer to BATTERY, DISCONNECTING AND CONNECTING .
-- Remove the front seat:
- Standard seat and Sport seat (manual). Refer to FRONT SEAT, REMOVING AND INSTALLING, MANUAL .
-- Attach the front seat to the Engine/Transmission Holder - Seat Repair Fixture:VAS6136 . Refer to FRONT SEAT, MOUNTING ON FIXTURE FOR SEAT REPAIR .
-- Remove tunnel side trim panel. Refer to SILL SIDE TRIM, REMOVING AND INSTALLING, MANUAL STANDARD/SPORT SEATS .
-- Remove the bolts -2- (quantity: 2).
-- Remove the seat height adjustment handle -1-.
-- Remove the lock washer -1-.
NOTE:
The bolts -1- and the bolt -3- are different lengths.
-- Remove the bolts -1- (quantity: 2) and -3- (quantity: 5).
-- Remove seat height adjuster -2-.