Overview - Front Backrest, Manual Standard Seat: Notes

WARNING: This page is about a different variant/trim than selected.

Fig 1: Exploded View Of Front Backrest

Courtesy of AUDI OF AMERICA, LLC

Seat Pan
Bolts
- 33 Nm
- Always replace if removed
- Threaded holes for bolts must be cleaned, for example, with a thread tap
- Self-locking
Backrest
- Removing and installing. Refer to FRONT BACKREST, REMOVING AND INSTALLING, STANDARD SEAT/SPORT SEAT/SUPER SPORT SEAT .
Headrest
- Removing and installing. Refer to HEADREST, REMOVING AND INSTALLING, HEADREST WITH SLIDING LOCKING MECHANISM .
Handle
- With bracket (entry assistance)
- Removing and installing. Refer to ENTRY ASSISTANCE HANDLE WITH BRACKET, REMOVING AND INSTALLING .
Entry Assistance Trim
- Removing and installing. Refer to ENTRY ASSISTANCE TRIM, REMOVING AND INSTALLING, MANUAL STANDARD SEAT .
Wiring Harness
- Running from the side airbag to the connector station.
- Depending on optional equipment, there may be more wiring harnesses, such as for backrest heating, lumbar support
Cables
- With entry assist
- Quantity: 2
- >>Entry Assistance<< Release Cable A, Removing and Installing. Refer to ENTRY ASSISTANCE RELEASE CABLE A, REMOVING AND INSTALLING
- >>Entry Assistance<< Release Cable A, Adjusting. Refer to ENTRY ASSISTANCE RELEASE CABLE A, ADJUSTING
- >>Entry Assistance<< Release Cable B, Removing and Installing. Refer to ENTRY ASSISTANCE RELEASE CABLE B, REMOVING AND INSTALLING
- >>Entry Assistance<< Release Cable B, Adjusting. Refer to ENTRY ASSISTANCE RELEASE CABLE B, ADJUSTING