Overview - Backrest Adjustment Motor
WARNING: This page is about a different variant/trim than selected.
NOTE:
The Backrest Is Shown Without The Cushion, Cover And Lower Seat Frame.
- Backrest Frame
- Nut
- 6 Nm
- Always replace
- Washer
- Shaft
- The threads must be cleaned before installing the nut -2- (for example, using a thread tap).
- Coat the threads on the shaft with locking fluid before installing the nut. For the correct locking fluid.
- Bolt
- 7.5 Nm
- Always replace
- Use locking fluid when installing the bolt. For the correct locking fluid.
- Backrest Adjustment Motor
- Driver side: Driver Backrest Adjustment Motor -V45-
- Front passenger side Front Passenger Backrest Adjustment Motor -V46-
- Removing and installing. Refer to BACKREST ADJUSTMENT MOTOR AND SWITCH UNIT, REMOVING AND INSTALLING .