Front Backrest, Removing And Installing, Power Standard Seat: Removing
- Follow all Safety Precautions when working with pyrotechnic components. Refer to SAFETY PRECAUTIONS .
- Before handling pyrotechnic components (for example, disconnecting the connector), the person handling it must "discharge static electricity". This can be done by touching the door striker, for example.
-- Turn on the ignition.
-- Disconnect the battery ground cable with the ignition turned on. Refer to BATTERY, DISCONNECTING AND CONNECTING .
-- Remove The Front Seat:
- Standard seat, Sport seat (power) and Comfort seat. Refer to FRONT SEAT, REMOVING AND INSTALLING, POWER .
- For the super sport seat. Refer to FRONT SEAT, REMOVING AND INSTALLING, POWER .
-- Attach the front seat to the Engine/Transmission Holder - Seat Repair Fixture:VAS6136 . Refer to FRONT SEAT, MOUNTING ON FIXTURE FOR SEAT REPAIR .
-- Remove the tunnel side trim. Refer to TUNNEL-SIDE TRIM, REMOVING AND INSTALLING, STANDARD SEAT, SPORT SEAT, SUPER SPORT SEAT and sill side trim. Refer to SILL-SIDE TRIM, REMOVING AND INSTALLING, POWER STANDARD SEAT, WITH OR WITHOUT MEMORY FUNCTION .
-- Using the Trim Removal Wedge:3409 , unclip the cable holder -1- in the corrugated tube -2- at the bottom side of the seat and remove the cable holder.
-- Disconnect all the wiring harness connectors to the backrest and free up the disconnected wiring harnesses.
The Wiring Harness Between The Connection Point And The Side Airbag Is Continuous.
-- Remove The Screws -2-.
-- Tilt the backrest -3- forward onto the lower seat frame -1-.
-- Press the seat pan upholstery to the side and carefully remove side airbag wiring harness -4- and, if necessary, all additional wiring harnesses -5- to the backrest (depending on equipment) from the seat pan.
-- Remove backrest.