Entry Assistance Trim, Removing And Installing, Power Standard Seat: Removing

-- Press the handle -arrow B- forward as far as the stop and hold it in that position.

Fig 1: Identifying Entry Assistance Trim

Courtesy of AUDI OF AMERICA, LLC

-- Press the tab -arrow A- off the fastener -arrow C- in the direction of the -arrow- using a Trim Removal Wedge:3409  .

-- Perform the same step on the opposite side of the trim -1-.

-- Tilt the trim -1- upward diagonally and remove from the handle with the bracket -2-.

-- Disengage the rear trim catch from the handle with bracket.

-- Remove the trim -1- from the handle with bracket -2- as far as the length of the entry assistance button wire allows.

-- Disconnect the electrical connector -1- on the entry assistance button -2-.

Fig 2: Identifying Entry Assistance Button

Courtesy of AUDI OF AMERICA, LLC

-- Remove the trim -3- with the entry assistance button.

-- Remove the entry assistance button. Refer to ENTRY ASSISTANCE BUTTON, REMOVING AND INSTALLING .