Entry Assistance Connecting Cable, Removing And Installing: Removing
- Follow all Safety Precautions when working with pyrotechnic components. Refer to SAFETY PRECAUTIONS .
- Before handling pyrotechnic components (for example, disconnecting the connector), the person handling it must "discharge static electricity". This can be done by touching the door striker, for example.
-- Turn on the ignition.
-- Refer to BATTERY, DISCONNECTING AND CONNECTING .
-- Remove The Front Seat:
- Standard seat and Sport seat (manual). Refer to FRONT SEAT, REMOVING AND INSTALLING, MANUAL .
- Standard seat, Sport seat (power) and Comfort seat. Refer to FRONT SEAT, REMOVING AND INSTALLING, POWER .
-- Attach the front seat to the Engine/Transmission Holder - Seat Repair Fixture:VAS6136 . Refer to FRONT SEAT, MOUNTING ON FIXTURE FOR SEAT REPAIR .
-- Remove the backrest cover. Refer to BACKREST COVER, REMOVING AND INSTALLING, TWO PIECE .
-- Remove the backrest frame trim. Refer to BACKREST FRAME TRIM, REMOVING AND INSTALLING .
-- Remove The Head Restraints:
- Refer to HEADREST, REMOVING AND INSTALLING, HEADREST WITH SLIDING LOCKING MECHANISM .
- Refer to HEADREST, REMOVING AND INSTALLING, POWER HEADREST .
-- Remove the entry assistance trim. Refer to ENTRY ASSISTANCE TRIM, REMOVING AND INSTALLING, MANUAL STANDARD SEAT .
-- Remove the cover with padding. Refer to BACKREST COVER AND CUSHION, REMOVING AND INSTALLING, STANDARD/SPORT SEAT .
-- Tilt the bracket -arrow- up as far as the stop and hold it in that position.
-- Disengage the connecting cable -1- at the bracket.
-- Push the handle -1- forward as far as the stop.
-- Disengage the connecting cable -2- at the handle.
-- Remove the connecting cable.