Center Bracket, Removing And Installing: Removing

WARNING: This page is about a different variant/trim than selected.

NOTE:

The Backrest Only Needs To Be Disengaged From The Mounts To Remove And Install The Center Bracket. The Release Cables In The Connector Stations Must Not Be Disconnected.

-- Remove the bench seat. Refer To SEAT BENCH/SINGLE SEAT, REMOVING AND INSTALLING .

-- Remove the right 2/3 section of the backrest. Refer To REAR SEAT BACKREST, REMOVING AND INSTALLING .

-- Remove the left 1/3 section of the backrest. Refer To REAR SEAT BACKREST, REMOVING AND INSTALLING .

-- Remove the bolts -1- (quantity: 4).

Fig 1: Identifying Center Bracket

Courtesy of AUDI OF AMERICA, LLC

-- Remove the center bracket -2- from the vehicle floor -3-.