Front Seat, Moving Into Service Position

Special Tools And Workshop Equipment Required 

• Trim Removal Wedge:3409 

Service Position, Implementing 

-- Bring headrest into lowest lock position.

-- Move seat as far back and up as possible.

NOTE:

For The Sake Of Clarity, The Figure Does Not Show The Surrounding Area.

Fig 1: Prying Cover Caps From Seat Rail Covers And Seat Fore/Aft Adjustment Spindle With Trim Removal Wedge 3409

Courtesy of AUDI OF AMERICA, LLC

Standard Seat (Manual): 

-- Pry the caps -1- off the seat rail -2- using the Trim Removal Wedge:3409  .

Standard Seat (Power):

-- Pry the caps -1- off the seat forward/back adjustment spindle using the Trim Removal Wedge:3409  .

Procedure For All Seat Versions: 

Fig 2: Connector Station Rear Cover

Courtesy of AUDI OF AMERICA, LLC

-- Unclip rear cover -1- with the Trim Removal Wedge:3409  and pull the cover in the direction of the -arrow- off of connector station -2-.

Service Position, Resetting

Install In Reverse Order Of Removal.Note The Following: 

-- Make sure the cover tab slides into connector station correctly.

-- Engage the cover correctly with the connector station.