LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 22 (SEAT FRAMES (2 Of 2) (COUPE)) >> 72 Seat Frames >> Front Seats >> Torsion Bar Bearing, Removing And Installing >> Installing

Torsion Bar Bearing, Removing And Installing: Installing

WARNING: This page is about a different variant/trim than selected.
WARNING:

The Torsion Bar Exhibits Considerable Spring Force. Always Follow The Points Below To Avoid Accidents: 

  • Always remove and install the torsion bar in the sequence described and only using the tools specified.
  • Never use pliers and other levers.
  • Do not stand directly in front of the torsion bar when removing and installing it. Stand off to the side.

Install In Reverse Order Of Removal. Note The Following: 

WARNING:
  • Follow all Safety Precautions when working with pyrotechnic components. Refer To SAFETY PRECAUTIONS .
  • Before handling pyrotechnic components (for example, connecting the connector), the person handling it must "discharge static electricity". This can be done by touching the door striker, for example.
NOTE:

Make Sure The Connectors Are Installed Correctly And Are Secure.

WARNING:

Ignition Must Be On When Connecting Battery. If Pyrotechnic Components (For Example, Airbag, Belt Tensioner) Are Not Repaired Correctly, They May Deploy Unintentionally After Connecting Battery. There Must Not Be Anyone Inside The Vehicle When Connecting The Battery.

-- Connect the battery ground cable with the ignition turned on. Refer To BATTERY, DISCONNECTING AND CONNECTING .

NOTE:

If The Airbag Indicator Lamp -K75- Indicates A Fault, Check The DTC Memory, Erase It And Check It Again Vehicle Diagnostic Tester.

scientia non olet · About LEMON Manuals