LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 22 (SEAT FRAMES (2 Of 2) (COUPE)) >> 72 Seat Frames >> Front Seats >> Seat Height Adjustment Motor, Removing And Installing >> Installing

Seat Height Adjustment Motor, Removing And Installing: Installing

WARNING: This page is about a different variant/trim than selected.
WARNING:
  • Follow all Safety Precautions when working with pyrotechnic components. Refer To SAFETY PRECAUTIONS .
  • Before handling pyrotechnic components (for example, connecting the connector), the person handling it must "discharge static electricity". This can be done by touching the door striker, for example.

-- Clean the threaded bolt holes for self-locking nuts, for example using a thread tap.

-- Replace all self-locking bolts.

-- Insert the bolt -2-.

Fig 1: Removing Bolt For Adjusting Spindle
GWWA72-10783Courtesy of AUDI OF AMERICA, LLC

-- Do Not Damage Bushing -1- When Inserting The Bolt.

Fig 2: Do Not Damage Bushing Inserted In Bearing Area When Removing Bolt
GWWA72-10792Courtesy of AUDI OF AMERICA, LLC
Fig 3: Adjusting Spindle/Seat Pan Bolting Torque Must Be Relieved
GWWA72-10782Courtesy of AUDI OF AMERICA, LLC
CAUTION:

If Tension Is Not Released When Loosening Or Tightening The Threaded Connection Between The Adjusting Spindle And The Seat Pan, The Threaded Hole In The Seat Pan Will Be Damaged Or Destroyed.

There Is A Risk Of Damaging The Threads On The Bolt -2-.

  • The bolt on the adjusting spindle has left-hand threads.

-- Do not damage the bushing -3- when inserting the bolt -2-.

CAUTION:
  • The bushings cannot be replaced with workshop materials.
  • If the bushings are damaged, the corresponding assembly parts must be replaced.

Install In Reverse Order Of Removal. Note The Following: 

NOTE:

Make Sure The Connectors Are Installed Correctly And Are Secure.

WARNING:

Ignition Must Be On When Connecting Battery. If Pyrotechnic Components (For Example, Airbag, Belt Tensioner) Are Not Repaired Correctly, They May Deploy Unintentionally After Connecting Battery. There Must Not Be Anyone Inside The Vehicle When Connecting The Battery.

-- Connect The Battery Ground Cable With The Ignition Turned On. Refer To BATTERY, DISCONNECTING AND CONNECTING .

NOTE:

If The Airbag Indicator Lamp -K75- Indicates A Fault, Check The DTC Memory, Erase It And Check It Again Vehicle Diagnostic Tester.

scientia non olet · About LEMON Manuals