Overview - Shift Unit
WARNING: This page is about a different variant/trim than selected.
NOTE:
The 6-pin connector with backrest lock switch and backrest forward stop switch are not separate from the bracket. They are delivered as a >>micro-switch with bracket<< switch unit -item ) OVERVIEW - SHIFT UNIT - Switch Unit (Micro-Switch With Bracket).
The locking bushing -item ) OVERVIEW - SHIFT UNIT - Locking Bushing and the screws for securing the switch unit -item ) OVERVIEW - SHIFT UNIT - Bolt are delivered as a replacement part.
The Backrest Is Shown Without The Cushion, Cover And Lower Seat Frame.
- Backrest Frame
- Bolt
- 1.5 Nm
- Quantity: 2
- Washer
- Nut
- Tightening specification. Refer To -item ) OVERVIEW - BACKREST ADJUSTMENT MOTOR - Nut.
- Always replace
- Shaft
- The threads must always be cleaned before installing the nut -item ) OVERVIEW - SHIFT UNIT - Nut (for example, using a thread tap).
- Coat the threads on the shaft with locking fluid before installing the nut. For the correct locking fluid.
- Locking Bushing
- Clipped to the spindle
- Clip to the spindle after adjusting the switch unit
- Switch Unit (Micro-Switch With Bracket)
- Removing and installing. Refer To BACKREST ADJUSTMENT MOTOR AND SWITCH UNIT, REMOVING AND INSTALLING .
- Adjusting. Refer To MICRO SWITCH, ADJUSTING, BACKREST LOCK SWITCH .
- Checking. Refer To MICRO SWITCH, CHECKING, BACKREST LOCK SWITCH .