Let Trim Release Lever Slide
-- LET TRIM RELEASE LEVER:T10039 slide along between sunroof cover frame -2- and headliner -1- until it touches one of the 15 clips -3-.
-- Release the clips one after consecutively using the Trim Release Lever:T10039 as shown in the image -arrow-.
Continuation For All Vehicles:
-- Remove the bolt -1- in the front interior/reading light roof opening.
- The Headliner Bends Easily.
- Replace The Headliner If It Is Bent.
-- Unclip the headliner -1- at the rear of the body in direction of -arrows- and let it hang by the limiting straps.
-- Carefully lower the front of the headliner.
A Second Technician Is Needed To Loosen The Limiting Straps And Remove The Headliner.
-- Disengage the headliner limiting straps -2- by pressing the catches together using needle nose pliers -arrows- and removing the clips from the body.
If It Is Difficult To Reach The Limiting Straps, Cut Them And Replace Them During Installation.
Remove The Headliner -1- Through The Passenger Door Opening.
-- Lower the front of the headliner and rotate it while tilting the left side down and guiding the left front corner of the headliner under the instrument panel -3-.
-- Remove right door seal -2- in the area of the B-pillar and the roof frame.
-- Remove the right front corner of the headliner at the B-pillar and roof frame until the opening comes into contact on the B-pillar.
-- Press the top of the headliner up on the B-pillar and the roof frame while guiding the bottom out at the side member and A-pillar.
-- Press the top of headliner -1- up on the B-pillar/roof frame and continue pulling out until the opening -arrow- comes into contact with the B-pillar.
-- Remove the headliner through the passenger door.