Side Trim Panel, Removing And Installing: Installing
WARNING: This page is about a different variant/trim than selected.
Install in reverse order of removal. Note The Following:
NOTE:
If Any Clamps And Clips Remain In The Body, Remove Them And Insert Them In The Trim.
Check clamps and securing clips for damage or deformation, replace if necessary.
-- Thread the belt webbing with seat belt latch through the belt extraction panel.
-- Install the rear belt anchor. Refer to REAR OUTER BELT END FITTING, REMOVING AND INSTALLING .
-- Position the side trim and press it on until all the mounting points engage.
-- Stretch the door seal lip over the side trim.