Lock Carrier Trim Panel, Removing And Installing: Installing
WARNING: This page is about a different variant/trim than selected.
Install In Reverse Order Of Removal. Note The Following:
NOTE:
If The Trim Clamps Remain In The Body Mounting Points, Remove Them And Insert Them In The Trim.
Check clamps for damage or deformation, replace if necessary.
-- Guide the left and right rear cross panel trim retaining tabs in the openings on luggage compartment side trim -1-.
-- Insert the rear cross panel trim so that the left and right tabs engage in pins -3-.
-- Push on the rear cross panel trim until it engages audibly and stretch the lip of the rear lid seal over the rear cross panel trim.