Speaker Trim, Removing And Installing, Center Speaker: Removing
WARNING: This page is about a different variant/trim than selected.
NOTE:
Be Extremely Careful When Removing And Installing Because It Is Easy To Damage The Speaker Trim.
-- Using a small screwdriver, carefully release the speaker trim -1- at the rear retaining pins in direction of -arrow- but only lift it up approximately 10 mm.
CAUTION:
Do Not Lift The Speaker Trim Any Higher Or The Front Retaining Pins Will Break Off.
-- Insert a long screwdriver under the speaker trim at the very front in direction of -arrow A- until it comes into contact directly on the right front retaining pins.
-- Carefully rotate the screwdriver in direction of -arrow B- until the retaining pin -1- disengages from the guide -2-.
-- Repeat the procedure on the remaining retaining pins -3-.