Instrument Panel Central Tube, Removing And Installing: Installing

WARNING: This page is about a different variant/trim than selected.

-- Carefully insert the instrument panel central tube -1- in the body.

-- Engage the instrument panel central tube on the A/C unit -3- and on the upper -2- and lower -4- stop brackets.

-- Align the instrument panel central tube -4- with the A-pillar.

Fig 1: Aligning Instrument Panel Central Tube -4- With A-Pillar

Courtesy of AUDI OF AMERICA, LLC

-- Tighten the two nuts -2 and 3- on threaded pin -1- and insert the threaded pin in mount -5- on the A-pillar on the driver side and tighten.

The threaded pin must be installed completely and its collar must make contact with the mount on the A-pillar.

-- Tighten the left and right instrument panel central tube bolts and nuts.

Install in reverse order of removal. Note The Following:

-- Install the steering column. Refer to STEERING COLUMN .

WARNING:

Ignition Must Be On When Connecting Battery. If Pyrotechnic Components (For Example, Airbag, Belt Tensioner) Are Not Repaired Correctly, They May Deploy Unintentionally After Connecting Battery. There Must Not Be Anyone Inside The Vehicle When Connecting The Battery.

-- Connect the battery ground cable with the ignition turned on. Refer to BATTERY .

NOTE:

If The Airbag Indicator Lamp -K75- Indicates A Fault, Check The DTC Memory, Erase It And Check It Again Vehicle Diagnostic Tester.